 printable version
Front fender
| Fig. 16.9. Front wing: 1 - the front wing; 2, 3, 4, 5, 8 - bolts 10 Nm; 6 - bolt 15 Nm; 7 - an arm
|
Front wing and its fastening elements are shown in Fig. 16.9.
Withdrawal Remove the front wheel. Remove the screws and remove the facing of a niche of a forward wheel.
| Fig. 16.10. Cover plate inner rear part of the front wing: 1 - screws; 2 - a protective cover; 3 - piston spacer; 4 - front wing
|
Remove the screws and remove the cover plate inside of the back of the front wing (Fig. 16.10). Remove the headlamp. Disconnect the electrical connector from the side repeater turn. Remove the bolts 2, 3, 4, 5, 6, 8 (see. Fig. 16.9) securing the front wing. Bolts coating protects the tool, and unscrewing is necessary to use new bolts.
Setting Installation is spent to sequences, return to removal, taking into account the following. Set the front wing on the car, align the bolt holes and tighten the screws 2, 3, 4, 5, 8 (see. Fig. 16.9) to 10 N ?� m, and the bolt 6 - 15 N ?� m. When installing the wing, make sure that the gaps between the fenders and hood, as well as between the wing and the front door were uniform over the entire length and is 3.0 ?� 1.0 mm.
|
