 printable version
Door frame
Withdrawal Removing the door frame it is carried out without removing the door. Remove the door trim.
| Fig. 16.42. Fasteners cable door lock and the lock rods: 1 - draft internal handle of opening of a door; 2 - pull door lock knob; 3 - a bolt of the pivot arm; 4 - clamps; 5 - wire door lock
|
Disconnect the 4 clips (Fig. 16.42) securing cable 5 door lock from the door. 3 Remove the bolt securing the pivot arm system door lock. 5 Disconnect the cable from the door lock of the pivot arm 3. 1 Disconnect draft from the internal handle of opening of the door. Disconnect the electrical connectors from the rear door pillar. Remove the corrugated protective cover, connecting the rear door and B-pillar. Marker mark the position of the door frame to the door.
| Fig. 16.41. Rear door / door frame: 1 - door frame; 2 - adjusting wedge plate; 3 - bolt 30 Nm; 4 - bolt 30 Nm; 5 - rear door; 6 - bolt 30 Nm; 7 - bolt 30 Nm
|
Remove the bolts 3, 4, 6, 7 (see. Fig. 16.41) and pull up the door frame.
Setting Installation is spent to sequences, return to removal, taking into account the following. Install door frame according to earlier put labels. Replace and tighten the screws by hand door frame 3, 4, 6, 7 (see. Fig. 16.41) with a control plate 2. By changing the position of the adjusting plate, you can change the slope of the door in the middle of the rack. Tighten 30 N ?� m bolts door frame in a sequence of 3, 7, 6, 4 (see. Fig. 16.41).
| 
