REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Chevrolet Lanos (since 2004 of release), Daewoo Lanos (since 1997 of release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Chevrolet
	Lanos
		Device Car
		Operating Guidelines
		Faults in the way
		Maintenance
		Engine
		Transmission
			Clutch
			Transmission
				Design Features
				Possible malfunctions of a transmission, their causes and remedies
				Changing the oil in the gearbox
				Replacement seals gearbox
				Removing and installing transmission
				Disassembly and assembly of the gearbox and its details Troubleshooting
				Repair of the secondary shaft
				Repair of the primary shaft
				Repair synchronizer
				Repair differential
				Repair gearshift
				Repair hinges drive gear
				Removal, installation and repair backstage gear lever
				Adjustment of a drive transmission control
			Front Wheel Drive
		Chassis
		A steering
		The brake system
		Electrical
		Body
		Wheels and tires
		Purchase of spare parts
		A trip to the STO
		Winter car operation
		Preparation for technical inspection
		Tips novice mechanic
		Applications
		Diagrams

printable version

Replacement seals gearbox

You will need: face head "10" driver with an extension cord, a flat-blade screwdriver, a hammer, a mandrel.

1. To replace the stuffing box half-line, remove the drive wheel to be replaced by the gland (see. "Removing and installing front wheel drive").


2. Remove the oil seal using a screwdriver.	3. Coat the lip of a new oil seal with gear oil and the press in its mandrel of suitable diameter inside the working edge of the box.


4. Input shaft lip seal is replaced by a vehicle removed from the gearbox after removing the release bearing (see. "Replacing the fork and release bearing"). Remove the three screws on the guide sleeve bearing clutch ...	5. ... and remove the guide sleeve.


6. mandrel of suitable diameter (eg, face head, "26"), press out the oil seal ...	7. ... and out of the sleeve.

8. Lubricate the lip of a new oil seal with gear oil and its press in the sleeve of the same mandrel, oriented so that when you install the hub gland working edge was directed inside the gearbox.

9. Install the parts in reverse order of removal.

NOTE

To replace the stuffing box shaft gear necessary to remove and disassemble the gearshift (see. "Repair of the gearshift").

« previos page
Changing the oil in the gearbox

next page »
Removing and installing transmission