printable version
Repair hinges drive gear
Drive gear: 1 - a tip of the shift lever; 2 - the shift lever; 3 - draft of a choice of transfers; 4 - Joint shaft gear; 5 - a shaft of a gear change; 6 - Joint gear lever
With an increase in the gaps in the drive gear there is vibration of the shift lever while driving, and the gear shift becomes blurred and difficult. In this case it is necessary to repair the joints of the drive. You will need a screwdriver. | | 1. To replace the hinge bushes gear lever press screwdriver axis of the lever locks ... | 2. ... and remove the axle from the holes of the hinge arm and the arm of a back support of the power unit. Take the gear lever from the bracket. |
| | 3. Remove the two plastic bushings from the holes of the hinge arm. | 4. Remove the plastic sleeve on each damping rubber bushings ... |
5. ... and O-rings. Hardened or damaged rubber plugs and replace the ring. 6. Assemble the hinge gear lever in the reverse order to dismantling. | | 7. To repair the hinge shaft gear, remove the spring clip ... | 8. ... and remove the hinge pin drive gear. Disconnect the plug joint. |
9. Remove the plastic fork shaft biscuit. 10. Assemble the joint draft of a gear in the reverse order to dismantling. | | 11. Thrust gear selection is made complete with hinges, so the appearance of backlashes in hinges, replace the thrust rod assembly. | 12. Press the plastic latch hinge ... |
13. ... and remove the hinge pin from the ball gear lever. 14. Similarly disconnect the second joint and remove the rod. 15. Install thrust gear selection in the reverse order of removal.
NOTE If after the repair of hinges of the lever and pull the shift, and after replacing the traction gear selection in the drive remained elevated play, then increase the clearance of the remaining non-separable hinges drive. In this case, replace the drive assembly. |
|