add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Chevrolet Lanos (since 2004 of release), Daewoo Lanos (since 1997 of release)

general info. full specifications. diagnostics. hints. tips. tricks
Chevrolet Lanos
Home
 
Chevrolet
Lanos
Device Car
Operating Guidelines
Faults in the way
Maintenance
Engine
Transmission
Chassis
A steering
The brake system
Electrical
Body
Design Features
Possible malfunctions of the body, their causes and remedies
Removing, dismantling and installation of bumpers
Removing and installing radiator grille
Removal and installation of mudguards of wheels and Lockers
Removal and installation of a forward wing
Removal and installation of a lattice box vozduhopritoka
Hood
Door
The trunk lid
Manhole cover fuel tank filler pipe
Seats
Removal and installation of facing of a tunnel floor
Restraint System (SRS)
Rear view mirrors
Dashboard
Heater and air conditioning
Interior fittings
Removal and installation of facing of salon
Removal and installation of facing the boot
Windscreen wiper
Replacement of the fixed glass body
Removing and installing the attachment flanges of the battery
Care body
Wheels and tires
Purchase of spare parts
A trip to the STO
Winter car operation
Preparation for technical inspection
Tips novice mechanic
Applications
Diagrams
 


Hit Counter by Digits


print page printable version

Removal and installation of facing of a tunnel floor



Facing the tunnel floor consists of two parts: the front and rear.
You will need a Phillips screwdriver with a blade.
1. Remove the two screws behind the back of the liner to the left ...
2. ... and right.

NOTE
The driver's seat is removed for clarity. To gain access to remove the lining of the seat anchorages are required.

3. Pull up the parking brake lever, push a little back of the lining back, bringing its gearing locks the front of the ...
4. ... and remove it by sliding up and down the parking brake lever.

NOTE
To remove the front part of facing the floor of the tunnel necessarily shoot back, enough to turn the screws of its fastening and push back a little.

5. Remove the front of the lining of the tunnel floor frame cover gear lever against the force of her retainers.
6. Through the window to install the cover gear lever disconnect the harness connector cigarette lighter.
7. Remove one screw securing the back facing the front of the ...
8. ... and the two screws in front.

NOTE
The second screw fastening the front part of the tunnel facing the floor located symmetrically about the longitudinal axis of the vehicle.

9. Expand the frame cover gear lever so that it is held in front of the opening facing the floor of the tunnel, and remove the front part of facing.
10. Install the side facing the tunnel floor in the reverse order of removal.




« previos page
Removing and installing rear seat
next page »
Restraint System (SRS)

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.