 printable version
Removal and installation of facing the boot
Trunk lining, molded of plastic body panels are attached to the pistons. Trunk floor mat of non-woven carpet material is laid on the floor of the vehicle, and is also attached to it four pistons arranged in front of the mat. You will need a flat-blade screwdriver. 1. Facing the rear left lamp is attached to the body with four pistons, three of them at a time is fixed and the back of the rear wheel arch liner. Remove the caps ... | | 2. ... having hooked a screw-driver ... | 3. ... and remove the trim. |
NOTE Facing the rear right lamp is removed similarly. |
4. To remove the lining of arch rear left wheel remove facing the rear light (see. Pp. 1-3), as the three percussion caps of its fastening both fixed and facing arch ... | | 5. ... remove the piston mounting arch lining of a back to the partition of the body ... | 6. ... and two pistons facing mounting rear sidewall, and at the same time securing the lining of the arch. |
7. Remove the trim left rear wheel arches. NOTE Facing the rear right wheel arch removed similarly. |
8. To remove the lining of the rear end panel, remove the four pistons fixing the upper part ... | | 9. ... and then, lifting the rear edge of the trunk mat and cover spare wheel, two pistons left and right fastening of facing to the side members of the body ... | 10. ... and one piston mount facing to the floor of the trunk, located in the center. |
11. Remove the end panel lining. 12. To remove the trunk floor mat, remove the four pistons its mounting along the front edge of the mat. 13. Install the luggage compartment lining and the floor carpet in the reverse order of removal.
| 
