REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Accent
		Instructions
		Engine
			Engines SOHC
				Technical data
				Toothed belt
				Check toothed belt tension
				Adjusting the tension of the toothed belt
				Ribbed Belts
				Engine Supports
				The front cover and the oil pump
				Air filter (ACL)
				Cylinder head
				Rocker
				Hydraulic jacks of backlashes of valves
				Replacing the valve seat
				Replacing the valve guide
				Valve
				Camshaft
				Cranks
				Crankshaft
				Flywheel
				The piston pin
				An exhaust manifold
				Intake manifold and the air chamber
				Cylinder block
				Removing and installing engine and gearbox
				Exhaust
				Troubleshooting
			Engines DOHC
		Greasing system
		Cooling
		Control, reduced toxicity
		Fuel system
		Ignition system
		Coupling
		Transmission
		Axes and power shafts
		Suspension
		Steering
		Brakes
		Body
		Air
		Electrical equipment
		Appendix
		Wiring

printable version

Adjusting the tension of the toothed belt

Adjusting the tension of the toothed belt automatically tensioning.

PERFORMANCE ORDER

1. Turn the steering wheel all the way counterclockwise.
	2. Support the engine oil pan with a wooden block and a little lift motor.
	3. Remove the left engine support.
4. Remove the water pump pulley.
	5. Remove the crankshaft pulley.
	6. Remove the top casing of a gear belt.
7. Check the toothed belt for bundles, damage and other defects. Ensure carefully checked that the entire length of the belt.
	8. Turn the crankshaft of the engine so that the piston of the first cylinder established at TDC in the compression stroke. Align the mark on the pulley of the toothed belt of the crankshaft with a pointer to the engine block. Check that the mark on the camshaft pulley are aligned with the pointer on the cylinder head cover.
9. Remove the bottom casing of a gear belt.
	10. Loosen the bolts 1 and 2 securing the tension mechanism in the sequence shown in the figure, with a spring mechanism unclench toothed belt tension.
	11. Check the position of the belt on the motor pulley.
12. Tighten bolts 1 and 2 securing the tension mechanism in the same manner.
13. Turn the clockwise crankshaft one full turn and align the label on a pulley of a gear belt of a cranked shaft with the index on the engine block.
A warning Do not turn the crankshaft counterclockwise.
14. In the same manner, loosen the bolts 1 and 2 fastening mechanism of a tension of a gear belt.
	15. Re-tighten the bolts 1 and 2 securing the tension mechanism in the same manner. Torque: 20-27 N ??? m
	16. Recheck the toothed belt tension. By clicking on the stretched arm of a gear belt with a force of 49 N timing belt should cave in to the center of the head bolts tightening mechanism.

« previos page
Check toothed belt tension

next page »
Ribbed Belts