REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Accent
		Instructions
		Engine
			Engines SOHC
				Technical data
				Toothed belt
				Check toothed belt tension
				Adjusting the tension of the toothed belt
				Ribbed Belts
				Engine Supports
				The front cover and the oil pump
				Air filter (ACL)
				Cylinder head
				Rocker
				Hydraulic jacks of backlashes of valves
				Replacing the valve seat
				Replacing the valve guide
				Valve
				Camshaft
				Cranks
				Crankshaft
				Flywheel
				The piston pin
				An exhaust manifold
				Intake manifold and the air chamber
				Cylinder block
				Removing and installing engine and gearbox
				Exhaust
				Troubleshooting
			Engines DOHC
		Greasing system
		Cooling
		Control, reduced toxicity
		Fuel system
		Ignition system
		Coupling
		Transmission
		Axes and power shafts
		Suspension
		Steering
		Brakes
		Body
		Air
		Electrical equipment
		Appendix
		Wiring

Replacing the valve guide

Valve Guides is set with the press. Using the tool to install the valve guide 09221-22000 or a suitable tool, replace the guide sleeve as follows.

PERFORMANCE ORDER

	1. Using the tool to install the valve guide, press out the valve guide from the cylinder head in the direction of the cylinder block.
2. Place the cylinder head to the opening of a new valve guide increased repair size.
3. Tool for fitting the valve guide 09221-22000 press in the sleeve in the cylinder head. The device provides the press-fit sleeve at certain depths. Measure the protrusion of the upper part of the valve guide from the cylinder head. Please note that the protrusion of the valve guide is different for intake (47.2 mm) and exhaust (39.1 mm) valve.
	4. After pressing the valve guides, insert new valves and check clearance.
5. Each time you replace the valve guides, check and, if necessary, replace the valve seat.

next page »
Valve