REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Accent
		Instructions
		Engine
		Greasing system
		Cooling
		Control, reduced toxicity
		Fuel system
		Ignition system
		Coupling
		Transmission
		Axes and power shafts
		Suspension
		Steering
		Brakes
		Body
		Air
			Technical data
			Instructions for use of the refrigerant
			Remarks at replacement of elements of the air conditioning system
			Merging an air-conditioning system
			Testing the air-conditioning system installed in the car
			Setting gauges for pressure measurement
			The evacuation of air from the air conditioning system
			Charge air-conditioning system
			Checking the coolant level
			Verification performance
			Oil for air conditioning compressor
			Relay test
			Air conditioning compressor
			Bushing clutch pulley and the air conditioning compressor
			The excitation coil clutch
			Check the compressor by car
			Triple Sensor (double) Pressure
			The fan and the condenser
			Evaporator
			Checking the thermostatic sensor (thermistor)
			The air filter of the evaporator
			Block heating and ventilation
			Block heater
			Fan
			Troubleshooting
		Electrical equipment
		Appendix
		Wiring

Checking the coolant level

PERFORMANCE ORDER

1. Start the engine, leave to work on frequency of rotation of the crankshaft 1500 rpm ^-1.

2. Turn the A / C switch to ON.

3. Set the temperature control to the maximum cold position.

4. Set the fan control knob to maximum speed.

5. After 5 minutes check whether a sufficient amount of refrigerant from the following table.

Check Point	The amount of refrigerant
Check Point	Too few	Not enough	Fine	Too much
The temperature of the tubes high and low pressure	There is almost no temperature difference between the pipe high and low pressure	The tube on the side of the high pressure warm, but on the low side - cold	The tube on the side of the high-pressure hot, but on the low side - cold	The tube on the high pressure side is too hot
Repairs	Stop the compressor and perform a full scan	Check for leaks, fix them and charge the air conditioning system		The tube on the high pressure side is too hot