REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Elantra (from 2000 to 2004, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Elantra
		Gasoline engines 1.6, 1.8 and 2.0 liters
		The diesel engine of 2.0 liters
		Greasing system
		Cooling
		Fuel system
		Control systems and emission control
		Ignition system
		The system of preliminary heating of the diesel engine
		Coupling
		Manual transmission
		Automatic Transmission
		Drive shafts, front and rear axles
		Suspension
		Steering
		Brakes
		Body
		The air conditioning system
			Technical data
			Instructions for use of the refrigerant
			Remarks at replacement of elements of the air conditioning system
			Merging an air-conditioning system
			Safety measures
			Setting gauges for pressure measurement
			Discharge the air conditioning system
			The evacuation of air from the air conditioning system
			Connecting the exhaust valve to the cylinder with the refrigerant
			Charge air-conditioning system
			Verification performance
			Oil for air conditioning compressor
			Check and adjust the tension of V-ribbed belts
			Air conditioning compressor
			Bushing clutch pulley and the air conditioning compressor
			The excitation coil clutch
			Checking clutch clearance
			Blower, and relay
			Receiver Drier
			Triple Sensor (double) Pressure
			Block heating and ventilation
			Fan
			Air filter
			Damper actuator supply fresh / recirculated air
			Check the fan motor
			Relay test
		Electrical equipment
		Electrical diagrams

Bushing clutch pulley and the air conditioning compressor

Withdrawal

PERFORMANCE ORDER

Remove the bolt sleeve coupling, with a special key 09977-34000 hold the sleeve against rotation.

Remove the plug and gasket to the clutch of the compressor shaft. If the sleeve is not removed, screw the bolt into the hole on the M8 shaft sleeve and remove the bolt sleeve.
Remove the retaining ring.
Remove the pulley and bearing compressor shaft.

Setting

PERFORMANCE ORDER

Clean the working surface of the bearing compressor pulley and remove traces of dirt and corrosion.
Install the pulley and bearing assembly on the compressor shaft.
Install the retaining ring beveled side facing outward.

Place one spacer spacer nominal thickness in the groove of the hub and install the plug on the compressor shaft.

Install the new plug and secure it with a bolt, having tightened its demanded moment. Torque: 11-14 N ??? m.

Do not use pneumatic tools.