REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Elantra (from 2000 to 2004, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Elantra
		Gasoline engines 1.6, 1.8 and 2.0 liters
		The diesel engine of 2.0 liters
		Greasing system
		Cooling
		Fuel system
		Control systems and emission control
		Ignition system
		The system of preliminary heating of the diesel engine
		Coupling
		Manual transmission
		Automatic Transmission
		Drive shafts, front and rear axles
		Suspension
		Steering
		Brakes
		Body
		The air conditioning system
			Technical data
			Instructions for use of the refrigerant
			Remarks at replacement of elements of the air conditioning system
			Merging an air-conditioning system
			Safety measures
			Setting gauges for pressure measurement
			Discharge the air conditioning system
			The evacuation of air from the air conditioning system
			Connecting the exhaust valve to the cylinder with the refrigerant
			Charge air-conditioning system
			Verification performance
			Oil for air conditioning compressor
			Check and adjust the tension of V-ribbed belts
			Air conditioning compressor
			Bushing clutch pulley and the air conditioning compressor
			The excitation coil clutch
			Checking clutch clearance
			Blower, and relay
			Receiver Drier
			Triple Sensor (double) Pressure
			Block heating and ventilation
			Fan
			Air filter
			Damper actuator supply fresh / recirculated air
			Check the fan motor
			Relay test
		Electrical equipment
		Electrical diagrams

printable version

Charge air-conditioning system

Charging the air conditioning system should be carried out in the gaseous state refrigerant through the low pressure side. When the cooling container is placed on the right side, the refrigerant will enter the system as steam.

PERFORMANCE ORDER

Connect the exhaust valve to the cylinder with refrigerant.

Open the low-pressure valve and adjust it so that the low pressure gauge indicates the pressure of not more than 412 kPa.

Place a container with a refrigerant to water heated to a temperature of 40 ?� C, to maintain the vapor pressure in the container is slightly higher than the vapor pressure in the system.

Start the engine in a mode of fast idling and the air conditioner.

Ensure that the container support rack to prevent the ingress of liquid refrigerant through the side of a low pressure, as this may damage the compressor.

Charge the system precisely set amount of refrigerant and close the discharge valve. The refrigerant quantity: 600 ?� '25 When the charging rate decreases, the refrigerant container is put in water heated to a temperature of 40 ?� C.

In all circumstances, the coolant can not be heated in water above a temperature of 52 ?� C (126 ?� F).

« previos page
Connecting the exhaust valve to the cylinder with the refrigerant

next page »
Verification performance