Front stabilizer

1. Remove the front wheel.

Remove the stabilizer rod.

Remove the bracket and stabilizer bushing.

Remove the rear engine mounting.

5. Remove the stabilizer bar.

1. Check the stabilizer bar on the lack of elasticity loss and damage.
2. Check all bolts.
3. Check the dust cover rod stabilizer for cracks or damage.

Check the torque that must be applied to crank pin of the spherical hinge of draft of the stabilizer.

??? If there are cracks in the protective cover, replace it and add grease in the joint.
??? Several times rocking from side to side of the hinge pin of the spherical thrust stabilizatora.Krutyaschy time: 1,7-3,2 N ??? m.
??? If the torque exceeds the allowable value, replace the stabilizer rod.
??? If the torque well below the allowable value, the ball joint can be reused if it is not jammed and is not excessive backlash.

1. Install the sleeve on the stabilizer bar.

The distance between the sleeve and the mark applied white paint should be 10 mm and placed on the outside of the vehicle.

2. Align the bracket with respect to the sleeve. Make sure that the bracket is securely covers the sleeve.
3. Temporarily secure the bracket bushing and install the sleeve on the second side of the stabilizer.