REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Jeep Grand Cherokee (from 1993 to 1999, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Jeep
	Grand Cherokee
		Introduction
		Adjustment and routine maintenance
		The straight six-cylinder engine
		The V8 engine
		Procedure of the general and engine major repairs
		Systems of cooling, heating and air conditioning
		The power supply system and exhaust
		The system of electric motor
			general information
			Starting the engine from the auxiliary power
			Check and replacement of wires of the battery
			Removing and installing battery
			Ignition System - general information
			Check of serviceability of functioning of the ignition system
			Check of serviceability and replacement of the ignition coil
			Check of serviceability and replacement of the camshaft position sensor
			Removal and installation of the distributor
			Charge system - the general information and precautions
			Check of serviceability of functioning of charge
			Removing and installing the generator
			Starting system
			Troubleshooting starter without removing it from the car
			Removing and installing starter
			Removal and installation of the traction relay (engines of 4.0 liters)
		Systems of decrease in toxicity of the fulfilled gases and engine management
		Manual box of a gear change
		Automatic Transmission
		Transfer Case
		Clutch and transmission line
		Brakes
		Suspension and steering
		Body
		The system of on-board electrical equipment
		Controls and operation receptions

Removing and installing the generator

PERFORMANCE ORDER

If the radio in your car is equipped by a security code before to disconnect the battery negative cable, make sure that you know this code.

Electrical connection of the generator.

Turn tensioner pulley clockwise removing the belt tension the belt type (shown by the engine 5.2 liters).

Remove the generator upper bracket bolts (shown engine 5.2 liters).

When replacing the generator take with you to the store old. Be sure to buy a new / rebuilt unit was identical to removal. Inspect the terminals - they must match in number, size and location. Finally, compare the identification numbers - they should be stamped on the body of the generator, or printed on a label attached to the body. Rooms of both units must be identical.
Most often, the new units are delivered without pulleys, so move the pulley to remove the generator to a new / rebuilt.
Install in reverse order.
After the installation of the generator make adjustment of the belt tension (Head of Adjustment and routine maintenance).
To check the serviceability of functioning of the new oscillator to measure its charge voltage (Section Check of serviceability of functioning of system of a charge).