REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Jeep Grand Cherokee (from 1993 to 1999, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Jeep
	Grand Cherokee
		Introduction
		Adjustment and routine maintenance
		The straight six-cylinder engine
		The V8 engine
		Procedure of the general and engine major repairs
		Systems of cooling, heating and air conditioning
		The power supply system and exhaust
		The system of electric motor
		Systems of decrease in toxicity of the fulfilled gases and engine management
		Manual box of a gear change
		Automatic Transmission
			general information
			Troubleshooting - General Information
			Removing and installing selector lever
			Check and adjustment of a cable switch
			Description, replacement and adjustment of the throttle cable mode kickdown (TV-cable)
			Check of adjustment and replacement of the gauge-switch of the permission of start
			Adjustment of a cable parking bollard
			Check and replacement of support of transmission
			Replacing the gland
			Description of the construction, removal and installation of lines and transmission cooling hoses
			Removal and installation of additional cooling
			Removing and installing automatic transmission
			Replacing the transmission control module (TCM) (only for the AW-4 and 42RE)
			Diagnosis of electronically controlled automatic transmission
		Transfer Case
		Clutch and transmission line
		Brakes
		Suspension and steering
		Body
		The system of on-board electrical equipment
		Controls and operation receptions

Removal and installation of additional cooling

Details of the installation of additional cooling (transmission 42RN and later 46RN)

PERFORMANCE ORDER

Remove the grille (Chapter Body).
Remove the condenser air conditioner if it will interfere with the implementation of the work (Chapter cooling systems, heating and air conditioning).
Label cooling line in order to guarantee correct connection of the assembly.
Place a container under the drain hose clamps cooler.
Loosen the clamp and remove the hose clamps.
Give all fixture coolant to the radiator and its support.

Details of the installation of additional cooling (AW-4 Transmission).

Details of the installation of additional cooling (transmission 42RE and early 46RN).

Remove the extra cooler.
Check the coolant hoses for cracks and cuts. Cut off the worn ends of the hoses. In the case of defects of the central portion of the hose (not at the ends), replace it.
Install in reverse order. Track reliability of a tightening of all fasteners and hose clamps.