| 1. The special adaptation OK130 331 016 insert two wheel bearing and remove the spacer to the knuckle. |
 | 2. Fix on the basis of the special adaptation OK130 331 016. |
 | 3. Tighten the nut of the special adaptation OK130 331 016 torque. Torque: 157-235 N ??? m |
A warning  Tightening the nuts evenly spending, increasing the torque each time by 5 N ??? m to prevent excessive preload.
|
| 4. Turn the steering knuckle to properly install the bearing rollers. |
 | 5. Special adaptation OK130 322 020, measure the preload of the bearings. Bearing preload: 0,25-1,17 N ??? m (2,5-11,7 H) |
| 6. If the bearing preload does not correspond to the desired value, choose a table from the spacer of appropriate thickness. |
A warning To reduce the tightness of bearings increase the thickness of the spacer, and vice versa. When the thickness of the spacer 1 rank tightness of bearings is changed to 0.2-0.4 N ??? m. Markings applied to the outer side of the spacer.
|
Marking | Thickness | 1 | 6.285 | 2 | 6,325 | 3 | 6.365 | 4 | 6.405 | 5 | 6.445 | 6 | 6.485 | 7 | 6,525 | 8 | 6.565 | 9 | 6.605 | 10 | 6.645 | eleven | 6,685 | 12 | 6,725 | 13 | 6,765 | 14 | 6,805 | 15 | 6.845 | 16 | 6.885 | 17 | 6.925 | 18 | 6.965 | 19 | 7,005 | 20 | 7.045 | 21 | 7,085 |
|
| 7. Remove special adaptation OK130 322 020. Remove inner and outer bearings and spacer. |
 |
A warning Fill the lithium lubricant the shaded area shown in the figure.
|
