 printable version
Removal and installation of an upholstery of a back door
You will need a screwdriver with a flat blade and Phillips. 1. Disconnect a wire from the plug ?�-?� the storage battery. |
| | 2. Hook screwdriver interior trim and doors, overcoming the resistance of latches, remove it. | 3. Remove the screw that secures the internal handle of the lock ... |
| | 4. ... pry traction drive lock, print them from clamps ... | 5. ... disconnect both traction drive from the castle ... |
| | 6. ... and remove the internal handle to lock the car. | 7. Remove the screw fastening ... |
| | 8. ... and prying with a screwdriver, remove the inside door handle. | 9. Remove the screws of the upper rear ... |
| | 10. ... and back to the bottom fastening of an upholstery of the door panel. | 11. Overcoming the resistance of six plastic holders, remove the trim from the door. |
NOTE So arranged plastic holders door trim (view from the back of the upholstery). Damaged holders replaced. |
| | 12. In order to gain access to the sites and units inside the door, remove the screw of the door handle ... | 13. ... remove the bracket ... |
| 14. ... and peel off the plastic on the door panels moisture proof film. |
15. Install the rear door trim and all previously removed parts in reverse order of removal. |
|
