REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Spectra (2004 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Spectra
		Device Car
		Operating Guidelines
		Faults in the way
		Maintenance
		Engine
		Transmission
		Chassis
		A steering
		The brake system
		Electrical
		Body
			Design Features
			Replacement bumpers
			Removal and installation of a mudguard and front wheel arch liner
			Removing and installing the rear wheel mudguard
			Removal and installation of a forward wing
			Removing and installing bonnet
			Door
				Removing and installing front door trim
				Replacing the glass front door
				Replacing the outer front door handle lock
				Replacing the front door lock
				Removing and installing front door
				Replacing the terminator of opening the front door
				Removal and installation of an upholstery of a back door
				Replacement glass back door
				Replacing the outer rear door handles
				Replacement lock the back door
				Removing and installing rear door
				Replace the rear door opening limiter
			The trunk lid
			Removal and installation of facing the boot
			The fuel filler flap
			Seats
			Supplemental Restraint System
			Rear view mirrors
			Dashboard
			Removal and installation of the instrument panel
			Heater and air conditioning
			Interior fittings
			Replacing a windscreen
			Care body
		Car Care
		Purchase of spare parts
		A trip to the STO
		Winter car operation
		Preparation for technical inspection
		Applications
		Diagrams

Replacement lock the back door

You will need: a screwdriver with a flat blade and Phillips, the key "10".

1. Lower the rear door glass.

2. Remove the rear door trim and moisture proof film (see. "Removal and installation of an upholstery of a back door").

3. Remove the inner and outer door laths (see. "Replacing the glass back door").


4. Remove the bolts of the top ...	5. ... and the bottom fastening back directing glasses ...


6. ... and remove the guide, pulling out of her pre-seal glass.	7. Remove the locking latch ...


8. ... and display of thrust retainers inside handle and door lock.	9. Disconnect the electric wiring harness pad lock ...


10. ... and, overcoming the resistance of the plastic latches, disconnect the connector harness from the door panel.	11. Remove the three screws securing the lock to the door ...

NOTE

Tighten the screws on the lock to the door can be pulled high moment, so for them to loosen, use the screwdriver shock.

12. ... and remove the lock from the door, bringing it out of engagement with the handle.

13. Install the front door lock and all the removed parts in reverse order of removal.