 printable version
Removing and installing strut front suspension
You will need: the keys "8", "14", "16", "17" face head "27" knob, extension, barbs. 1. Open the hood and place it on the palm. |
2. Remove the wheel covers from the replaceable rack and tighten the wheel nuts (see. "Changing a wheel"). |
| 3. beard raskontrite hub nut. |
WARNINGS When loosening the hub nut car should stand on the ground! Loosen or tighten the wheel nuts only on the car standing on the earth. |
| | 4. Loosen the nuts of the front hub. | 5. Remove the protective cover of the top support strut. |
| | 6. Loosen the shock absorber rod nut, holding the rod against rotation (if you are shooting the strut to replace her body, a spring or the top support). | 7. slow down the car and set the parking brake, wheel chocks ("shoes") under the rear wheels. Loosen the wheel nuts. Lift the front of the car jack and set it on supports. Remove the wheel. |
| | 8. Remove from the slot in the bracket strut rubber brake hose holder and move it to the side. | 9. Remove the nut ball stud stabilizer strut to the bracket holding the second key ball pin from turning ... |
| | 10. ... and detach the arm ball stud. | 11. Remove the nut of the upper strut mounting bolts to the steering knuckle, holding the bolt head from turning ... |
| 12. ... and remove the bolt. |
13. Similarly, remove the lower bolt. |
HELPFUL HINTS At the complicated removing bolts strut to knuckle knock them mandrel of suitable size. Before installing Grease bolts strut to knuckle, then to make them easier to turn out. |
| 14. Remove the hub nut, output shank of the external hinge of equal angular speeds of the front wheel, relegating the strut to the side, and hang on the wire drive. |
HELPFUL ADVICE At the complicated breeding shank outer hinge gently without damaging the thread, knock him out of the hub mandrel of suitable size. |
A WARNING Make sure that the drive shaft is not released from the case of the internal hinge, as this may damage the hinge. |
| | 15. Remove the four nuts of the top support to the body. | 16. Hold the rack, take the knuckle from the strut ... |
| 17. ... and pull out the rack assembly down through the wheel niche. |
18. Place the rack in the reverse order of removal. |
|
