add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 3 (2003 release)

general info. full specifications. diagnostics. hints. tips. tricks
Mazda 3
Home
 
Mazda
3
Operation and maintenance of car
Engine
General description new engines models L8, LF, L3
The mechanical part of engines
Engine Model L8 or LF
Checking the contents of the CO / CH in the exhaust gas
Measurement of engine compression
Verify accessory drive belt
General information and safety when removing the power unit
Removal of sealant
Removal and installation of the power unit
Check actuator variable valve timing (L3)
Removal and installation of the actuator variable valve timing (L3)
Timing chain drive
Removal and installation of the oil control valve (OCV) (L3)
Checking the oil control valve (OCV) (L3)
By operation of the spool valve (OCV) (L3)
General repair operations on the power unit
Dismantling the cylinder head (beginning)
Dismantling the cylinder head (end)
Dismantling cylinder (beginning)
Removing and installing crankshaft rear oil seal
Dismantling cylinder (the end)
Check the cylinder head
Assembling the cylinder (the beginning)
Assembling the cylinder (the end)
Assembling the cylinder head
Assembling the valve timing
Appendix 1
Annex 2
Appendix 3
Engine Z6 - mechanical part
Lubrication system
Cooling system
Intake system
Fuel system
Exhaust and Emission
Ignition system
Control system
Tables
Transmission
Chassis
Steering Gear
Brakes
Onboard electric
Body
 


Hit Counter by Digits


print page printable version

Removing and installing crankshaft rear oil seal



Removing the crankshaft rear oil seal
Fig. 2.130. Removing the crankshaft rear oil seal 1 - bolts; 2 - gland


Unscrew the six bolts securing rear oil seal and remove the gland (Fig. 2.130).

Places applying sealant
Fig. 2.131. Places applying sealant


Kremnievoorganichesky Apply sealant to the mating surfaces in the location shown in Figure 2.131. The diameter of the point of application of 0.4-0.6 mm.
Apply clean engine oil to the lip of a new oil seal.

Installation scheme crankshaft rear oil seal
Fig. 2.132. Installation scheme crankshaft rear oil seal: 1 - the crankshaft; 2 - rear oil seal; 3 - a device to install; 4 - cylinder block


Install and press-fit the rear oil seal using the device for installation details as shown in Figure 2.132.

Order of a tightening of bolts securing crankshaft rear oil seal
Fig. 2.133. Order of a tightening of bolts securing crankshaft rear oil seal


Tighten the rear oil seal in the manner indicated in Figure 2.133, torque 8,0-11,5 Nm.




« previos page
Dismantling cylinder (beginning)
next page »
Dismantling cylinder (the end)

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.