 printable version
Rear anti-roll bar
| Fig. 255. The rear anti-roll bar: 1 - a nut M12; 2, 13 - silent blocks; 3 - Front stabilizer; 4 - M12 90-95 Nm; 5 - the stabilizer bar; 6 - a bolt M8 20-25 Nm; 7 - the holder; 8 - square nut; 9 - a nut M8; 10 - washer; 11 - M8 screw; 12 - mounting bracket
|
In Fig. 255 is shown mounting rear axle to the rear axle. Stabilizer used for its attachment to the chassis. To remove the car stabilizer reliably we establish on support. Removing the rear antiroll bar should be carried out as follows:
| Fig. 256. Attaching stabilizer
|
- On both sides to turn on the top rack of the stabilizer. This compound was shown in Fig. 256. Follows Loosen the nut 1 and the bolt 4 (see. Fig. 255); - Unscrew the nut 8 mounting brackets 12 and remove the screws 6; - Pull rod 5 with stabilizer straps; - Unscrew the nut 9 7 holders and remove the bolt 6. Remove the holder; - Remove the bracket 12 to 13 Hob and remove both of the details with stabilizer bar; - Unscrew the rack 3 from the tip stabilizer. If necessary, replace the old drive out silent blocks and drive new. Hobs 2 stabilizer and the stabilizer can be replaced. When installing new for ease of installation moisten them with soapy water. When you install, proceed as follows: - Secure the rack to the stabilizer; - Set Hob 13 on the side of the stabilizer bar and slide the bracket on it. If necessary, apply talcum powder on Hob; - Fasten the plate holder 7 to the bracket and tighten the bolts; - Fasten the post holder with the racks to the attachment points on the chassis; - To put the stabilizer in the middle and tighten the screws on top and bottom racks torque 90-95 Nm; - Connect the mounting bracket tighten to 20-25 Nm.
| 
