 printable version
Adjusting the wheel bearing endplay
Adjust the wheel bearing endplay must be carried out as follows: - The front part of the car mounted on a support; - Remove the front wheel with the right hand; - Squeeze the brake pads against the disc. If necessary, unscrew the support, so that they can move freely;
| Fig. 212. Removal of the gland Kit: 1 - the hub of the front wheel; 2 - Puller hub gland; 3 - Cover Kit
|
- To remove the hub cap. To this end generally use puller shown in Fig. 212;
| Fig. 213. Adjustment of wheel bearing 1 - the hub of the front wheel; 2 - locking clip; 3 - axis; 4 - an adjusting washer
|
- According to the figure. 213 loosen the Allen bolt with the locking clip 2 and while turning the hub terminal to move as long as it will not be free to rotate; - Then unscrew the bolt locking clip 1/3 turn. Plastic mallet at the end of the axis 3, weaken the force between the parts;
| Fig. 214. Measuring endplay front hub: 1 - a nave; 2 - the holder of the stock; 3 - control device
|
- Set the control device 3 (Fig. 214) from the magnetic holder on the hub shaft 2 and 1 draw in about 2 mm; - To measure the axial play of the hub. Before each measurement, rotate the hub, but not during the measurement. Backlash should be in the range of 0.2 to 0.4 mm; - Allen key to tighten the bolt clamp locking torque 10-16 Nm and then measure the backlash of the bearing hub. The play is set correctly, if the washer located between the outer bearing and clamp can rotate with little effort; - Apply grease to the hub cap and drive; - Establish a wheel and lower the car. Tighten the wheel bolts torque of 160-180 Nm.
| 
