 printable version
Replacement wheels
Replacement wheels must be performed in the following order: - To slow down the vehicle parking brake and engage first or reverse gear; - Under the wheel located on a diagonal from the shoot, put a bar; - Loosen all the wheel bolts; - To raise the jack with the right hand;
| Fig. 340a. Position the spare wheel on a minibus (installed under the frame on the back side) 1 - bolts of the holder; 2 - wheel holder
|
- Remove the spare wheel. Its location is shown in the manual. Owners of used cars often have no leadership. Therefore, the following is a description of three possible locations for the spare wheel (Fig. 340a, 340b and 341). If you do it the first time, consider the following: - On Fig. 340a shown in Mount the spare wheel vans. For its removal to open the rear doors, wheel wrench unscrew bolts 1 of the carrier element 2 of the wheels and lower the holder. Lay the carrier element to the side and remove the wheel;
| Fig. 340b. Position the spare wheel on the car with a cargo platform (installed under the frame on the back side): 1 - the spare wheel carrier; 2 - Stop Bracket
|
- On Fig. 340b shown mounting a spare wheel on the car with side platform - it is under the rear frame. To remove the hand unscrew the wing nuts and fastening - the correct key. Holder 1 bit to lift, push aside the carrier element 2 and remove the wheel;
| Fig. 341. The position of the spare wheel on-board a vehicle with a cargo platform (installed under the platform)
|
- On Fig. 341 also shows mounting of a spare wheel located under the platform of the on-board the vehicle. To remove the bolts loosen, move the wheel to the side and unscrew the holder.
Note When installing a damaged wheel on storage put a spare wheel disc downwards. For security reasons, you should regularly check the spare tire mount. |
Further tire must be as follows: - Loosen the wheel bolts;
A warning To remove the wheel on the road often have to close drain covers, so be careful - do not lose Remove the bolt. If possible, move the vehicle slightly forward. |
- Remove and install the wheel on the hub spare; - Screw on the hand closest to the valve wheel bolt so that the wheel into place. Secure the remaining bolts; - Firmly tighten screws crosswise by turning the wheel, so that it properly centered on the hub; - To lower the car and tighten the bolts to 160-180 Nm. Not overtighten not to move the brake pads or the drum, - it can result in uneven braking and tire wear; - In any case, check a few kilometers bolts.
| 
