|
|
 printable version
Dual brake master cylinder
Dual brake master cylinder
 | 1 - Planting seal tank
2 - Cuff
3 - The piston (a follower)
4 - Lock washer
5 - Retaining Ring
6 - Vacuum seal
7 - The intermediate ring
8 - Clip
9 - Fill the washer
10 - Primary coupling
11 - foot ring
12 - Plate spring
13 - Float
14 - Connecting screw
15 - Locking screw
16 - Cover tank
17 - Spring | 18 - Ring clutch
19 - a spring plate
20 - Piston (the contour of the float)
21 - Spring
22 - Housing
23 - Splash Screen
24 - Strainer
25 - Cover
26 - compensator
27 - contact insert
28 - Seal
29 - Location of the locking screws stepper tandem |
Elements of the master cylinder
 | 3, 7, 20 - Pistons
5 - Retaining Ring
8 - Locking plate
9 - Cork | 10 - Tank
22 - Housing
27 - Guide pin |
The main brake cylinder of the "tandem" is shown in the illustrations.
Dismantling
|  | 1. Lightly press the pin (3) and remove the cylindrical pin (27) with a pair of pliers. |
 | 2. Remove the retaining ring (5) and remove the piston (3), together with the secondary seal from the housing (22). |
3. Remove the floating piston with a pair of pliers from the housing (22).
4. Wipe the body and check the interior surface of the housing for damage.
5. Clean all parts of the new brake fluid. |
|
Assembly
|  | 1. Disconnect the plug (040) of the sleeve (041). |
2. Remove the oil seal and the secondary piston from the hub (041).
3. Secure the housing (22) holes down.
4. Grease the body bore (22) of brake fluid.  | 5. Insert the plug (040) into the hole and press in floating piston (20) to the stop by using a screwdriver. When installing the piston, make sure that the guide groove (arrow) is mounted vertically. |
6. Insert the cylindrical pin and remove the sleeve (040).
7. Attach the brake cylinder holes up.
8. Insert the secondary oil seal into the housing (22) and press in it.  | 9. Secure the piston (7), insert the lock plate (8) and secure it with the retaining ring (5). Make sure that the retaining ring (5) is correctly positioned in the groove of the body (22). |
 | 10. Lubricate the plug (9) and press in the brake fluid of the body (22). Set the tank (10) from one tube to the housing (22), rotate by 180 ?� and then install a second tube to the housing (22). |
|
|
|
|
