|
|
 printable version
Removing and installing radiator
Radiator and fan
 | 1 - Pin, the fastening member, a front center
2 - Rubber Bearing top
3 - cover, the fastening member, a front center
4 - Duct top
5 - Rivet, mounting plate, front center
6 - Cable holder | 7 - the lower duct
8 - The fan
9 - Rubber Bearing lower
10 - Radiator
11 - Guide to the air going to the central module |
Radiator and expansion tank
 | A - 4-cylinder gasoline engine 111
B - 6-cylinder petrol engine 112
C - Diesel Engines
1 - nut expansion tank
2 - Cover
3 - Expansion tank
4 - sensor switch coolant level indicator | 5 - Vent hose
6 - Radiator
7 - Radiator Hose Upper
8 - Radiator Hose Lower
9 - coolant conduit
10 - Condenser |
Models with Manual transmission
Withdrawal
| 1. Remove the blower motor, refer to the appropriate section.
2. Remove the beep, refer to Section Removal and installation of the audio signal.
3. Disconnect the hydraulic line from the hydraulic booster of the castle.
4. Remove the bracket lock at the bumper.
5. Open the clip 3 from the top of the castle.
6. Disconnect the connector at the right bonnet.
7. Cut and remove the cable from the connector holder lock.  | Mark installation position marker. |
8. Remove the drive hood.
9. Remove the bracket lock.
10. Drain the coolant, refer to the appropriate section.
11. Remove the radiator hoses. To do this, squeeze the appropriate bracket with a screwdriver so that it is locked.
12. Press the clamps on the left and right at the sink. At the same time pull the upper part of the condenser forward and remove it from the bottom.
13. Remove the radiator up. |
|
Setting
| 1. Set the capacitor in place. At the same time, take care that the pins at the bottom of the radiator sat in the rubber feet.
2. Set the bottom of the condenser in the holder and fasten the top of the retainer.
3. Set the hose with the new O-rings.
4. Further installation is performed in reverse order of removal. |
|
|
|
