REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz G-Class (W463, 1999 issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mercedes-Benz
	G-class
		Introduction
		Controls and operation receptions
		Current care and maintenance
		Engine
		System of cooling, heating, ventilation and air conditioning
		The power supply system and exhaust
		Systems of an electric motor
		Automatic Transmission
		Transmission Line
		Brakes and auxiliary systems
		Suspension and steering
			Specifications
			Front suspension
			Rear suspension
				Overview
				Removing and installing rear axle assembly
				Removal, check and installation of the rear shock absorbers
				Removal and installation of the front suspension springs
				Removing and installing rear stabilizer bar
				Removing and installing trailing arm suspension
			Steering
			The suspension geometry
		Body
		Onboard electric
		Wiring

Removal and installation of the front suspension springs

Replacement suspension springs must be done in pairs for each axis!

PERFORMANCE ORDER

At a corresponding complete disconnect from the crankcase rear axle traction control brake pressure (see. Conjugated. Illustration - the model without EBV).

Prop up the front wheel chock, Poddomkratte rear axle, then start the backup for the longitudinal control arm brackets.

Release nuts and remove the bolts of the lower strut (see. Section Removal, check and installation of the rear shock absorbers).

Lower the bridge and remove the coil springs suspension - try when lowering the bridge does not pinch the brake lines.

Installation is in the reverse order - make sure that the ends of the rod springs ran into a special projection of the lower plates.

Replacement springs should have the same color coding as the original.