 printable version
Adjusting the clutch
Clutch parts It may take two adjustments - adjust the height of the clutch pedal and the clutch pedal backlash adjustment. Adjusting the height of the clutch pedal Pedal height "H" (see. Illustration below) should be 159.5 - 169.5 mm. To adjust, loosen the nut (2) Pedal (3) and slide the fence until the height does not match the required value. Tighten the lock nut with a force of 16-22 N ??? m. Elements adjust the clutch pedal  | 1 - the pedal
2 - locknut
3 - stop bolt pedal
4 - mat
5 - floor insulation
6 - asphalt pad
7 - floor panel
A = clearance pedal
H = height of the pedal |
Adjusting the pedal backlash  | Items to adjust the clutch cable. Lying gap between the arrows "A" on the release lever must be adjusted by a nut (2) after loosening the lock nut (1). |
Pedal free play must be adjusted, if the clutch is bad off, or after the installation of new parts. Guided by the above illustration: | - Loosen the lock nut (1) and move the adjusting nut (2) on the inner side of the fork, until the gap A between the arrows will not lie in the range of 2.5 to 3.5 mm.
- Again, tighten the locknut (1).
- Several times the clutch pedal and check the play again.
|
|
| 
