printable version

The guide shaft bearing clutch

Guide bearing on the inner side of the flywheel can be checked in the mounted state by entering the index finger into the bearing and rotate it from side to side, moving it at the same forward and backward.

If there are jamming or excessive backlash, bearings can be replaced. To remove the bearing is best to use a hammer with sliding brisk. The flywheel may still be installed or removed. Install a suitable adapter for the inner race of the bearing and install the adapter hammer with sliding brisk. Knock out the bearing. Drive a new bearing into the flywheel, until it is flush with the outer side of the flywheel.