REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Passat B6 (from the year 2004)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Volkswagen
	Passat B6
		Operation and maintenance of car
		Engine
			Overview
			Mechanical (engine capacity of 1.6 liters)
			Lubrication system
			Cooling system
			Fuel Injection System
			The mechanical part (petrol engines of 2.0 liters)
			Lubrication system
			System ohlazhdeiya
			Fuel system
			Injection system
			System of release of gases otrabotavschih
			Ignition system
			The mechanical part (diesel engines of 2.0 liters)
				Removing Engine
				Removing and installing V-ribbed belt
				Replacing crankshaft oil seal on the side of the pulley
				Removing and installing sealing flange on the side of the pulley
				Replacing crankshaft oil seal on the flywheel side
				Removal and installation of the gauge of number of turns of the motor shaft
				Removing and installing needle bearing flywheel
				Piston and connecting rod
				Cylinder Head
				Removing and installing cylinder head cover
				Removal, installation and tension of the toothed belt
				Removal and installation of the cylinder head
				Valve gear
				Removal and installation of roller levers exhaust valves
				Removal and installation of roller levers intake valves
				Checking the valve guides
				Replacing valve stem seals
				Removal and installation of camshafts
				Removing and installing camshaft oil seal
			Lubrication system
			Cooling system
			Fuel system
			Turbocharging turbo running on exhaust
			The direct injection diesel
			Exhaust
			Tables
		Transmission
		Chassis
		Steering Gear
		Brakes
		Onboard electric
		Body
		diagrams

printable version

Valve gear

Fig. 2.305. Valve gear: 1 - cable holder, 10 Nm; 2 - a bolt 20 Nm; 3 - axis roller levers; 4 - a bolt 20 Nm + tighten 1 / 4ob. (90 ?�); 5 - a bolt of the cylinder head; 6 - washer; 7 - conical biscuit; 8 - a plate of the valve spring; 9 - a spring valve; 10 - the valve stem seals; 11 - the directing plug of the valve; 12 - roller lever-inlet; 13 - Roller-release lever; 14 - gland; 15 - cylinder head; 16 - inlet valves; 17 - exhaust valves; 18 - O-ring; 19 - insertion axis; 20 - bolt 10 Nm; 21 - the locking bolt; 22 - insertion axis; 23 - bearing; 24 - exhaust camshaft; 25 - inlet camshaft; 26 - Module supports

Mounting position of the mixing tube

Fig. 2.306. The groove connection tube

Paz connecting tube shows the top (Fig. 2.306).

Checking camshaft axial clearance

Fig. 2.307. Checking camshaft axial clearance

Check the axial clearance of the camshaft.

The maximum tolerance max. 0.15 mm.

« previos page
Removal and installation of the cylinder head

next page »
Removal and installation of roller levers exhaust valves