REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Passat B6 (from the year 2004)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Volkswagen
	Passat B6
		Operation and maintenance of car
		Engine
			Overview
			Mechanical (engine capacity of 1.6 liters)
			Lubrication system
			Cooling system
			Fuel Injection System
			The mechanical part (petrol engines of 2.0 liters)
			Lubrication system
			System ohlazhdeiya
			Fuel system
			Injection system
			System of release of gases otrabotavschih
			Ignition system
			The mechanical part (diesel engines of 2.0 liters)
				Removing Engine
				Removing and installing V-ribbed belt
				Replacing crankshaft oil seal on the side of the pulley
				Removing and installing sealing flange on the side of the pulley
				Replacing crankshaft oil seal on the flywheel side
				Removal and installation of the gauge of number of turns of the motor shaft
				Removing and installing needle bearing flywheel
				Piston and connecting rod
				Cylinder Head
				Removing and installing cylinder head cover
				Removal, installation and tension of the toothed belt
				Removal and installation of the cylinder head
				Valve gear
				Removal and installation of roller levers exhaust valves
				Removal and installation of roller levers intake valves
				Checking the valve guides
				Replacing valve stem seals
				Removal and installation of camshafts
				Removing and installing camshaft oil seal
			Lubrication system
			Cooling system
			Fuel system
			Turbocharging turbo running on exhaust
			The direct injection diesel
			Exhaust
			Tables
		Transmission
		Chassis
		Steering Gear
		Brakes
		Onboard electric
		Body
		diagrams

printable version

Checking the valve guides

Fig. 2.311. Determining backlash valve guides

Insert the new valve into the guide sleeve. The end of the valve stem must overlap the guide sleeve. Due to the different diameter shaft using only intake valve guide sleeve of the intake valve and exhaust valve of the exhaust valve in the sleeve, respectively.

Determine play with rocking valve. The maximum tolerance max .: 1,3 mm.

If the backlash exceeds the limit values of wear - replace the cylinder head.

« previos page
Removal and installation of roller levers intake valves

next page »
Replacing valve stem seals