add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Passat B6 (from the year 2004)

general info. full specifications. diagnostics. hints. tips. tricks
Volkswagen Passat B6
Home
 
Volkswagen
Passat B6
Operation and maintenance of car
Engine
Overview
Mechanical (engine capacity of 1.6 liters)
Removal and installation of the top casing of the engine
Check the timing belt (4-cyl. Petrol engines of 1.6 liters)
Removing Engine
Engine installation
Disassembly and assembly of the engine
Removing and installing V-ribbed belt
Removing and installing timing cover
Replacing crankshaft oil seal on the side of the pulley
A method of tightening the mounting bolt sprocket belt drive
Dismantling and assemblage of pistons and rods
Cylinder Head
Checking the valve timing
The timing
Removing and installing the camshaft housing
Removal and installation of the cylinder head
Compression Test
Repair the valve mechanism
Checking the valve guides
Replacing valve stem seals
Lubrication system
Cooling system
Fuel Injection System
The mechanical part (petrol engines of 2.0 liters)
Lubrication system
System ohlazhdeiya
Fuel system
Injection system
System of release of gases otrabotavschih
Ignition system
The mechanical part (diesel engines of 2.0 liters)
Lubrication system
Cooling system
Fuel system
Turbocharging turbo running on exhaust
The direct injection diesel
Exhaust
Tables
Transmission
Chassis
Steering Gear
Brakes
Onboard electric
Body
diagrams
 


Hit Counter by Digits


print page printable version

Compression Test



Test condition
Engine oil temperature must be at least 30 ?� C.

The order of execution of works
Remove the air filter.
Remove the ignition coil. To do this, use a wheel puller.
Remove the spark plug spark plug wrench.

Terminal with fuses
Fig. 2.44. Terminal with fuses


Remove the fuse from the fuse holder SD34 right front panel (Fig. 2.44).

NOTE
By removing the fuse SD34 interrupted power control unit of the fuel pump.
Measure compression using compression tester.

NOTE
Maintenance compressometer described in the corresponding manual.

Scroll to the starter until the compression gauge stops to show growth pressure.
Compression:
- A new engine - 10-15 barg.
The maximum tolerance of 7 barg.
Permissible differences between the individual cylinders 3 bar.
Screw the spark plug spark plug wrench and tighten them to a torque of 30 Nm.
Further installation is performed in reverse order.
Interrogate fault memory, eliminate the presence of any errors, and then clear the memory.
After clearing the fault memory is necessary to create a code of readiness (Readinesscode).




« previos page
Removal and installation of the cylinder head
next page »
Repair the valve mechanism

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.