 printable version
Replacing the lamp beam
NOTE Lamp left and right low beam lamp beam can check with the diagnosis of the actuators onboard supply control unit. |
Withdrawal Turn the ignition and all electrical consumers and translate the key to position 0 (pre-emphasis).
NOTE Put the ignition key on the remote control during removal and installation into the vehicle in order to avoid blocking doors and self-activation of the ?�Coming Home / Leaving Home (home Arrival / Departure from the house)." |
To replace the lamp beam must be removed adjacent parts corresponding lights.
NOTE The illustration shows replacement of the lamp beam on the right headlight. Replacing left headlight light and the right headlight light the same way.
|
Loosen the cartridge with a lamp beam 1 in the direction of the arrow and pull it out of the spotlight so far as the length of the wires (Fig. 7.50).
Remove the lamp beam 2 in the direction of the arrow out of the cartridge 1 (Fig. 7.51).
Setting When installing the lamp, do not touch its glass surface. Fingers are left on the glass bulb greasy fingerprints that evaporate after the lights and light the lamp may become darker.
NOTE When installing pay attention to the tight fit of the cap. Ingestion of water lights, headlamp may be spoiled. |
Plug a lamp into the socket beam so that the projection lamp 1 against the guide 2 cartridge (Fig. 7.52). Install the cartridge with a lamp beam 1 headlight and turn the cartridge with a lamp beam in the direction of the arrow (Fig. 7.50). Reinstall the cap. Check the operation of lights, including all of its functions. Check the setting of the headlights, if necessary - adjust.
| 
