 printable version
Additional heat exchanger
Removing additional motor and a heat exchanger | 1. Grate in the cabin
2. Laying
3. Additional radiator
4. Coolant
5. Return the coolant |
Additional radiator heater is located underneath the car at the height of the sliding door. The work is similar to the front heating: motor draws in clean air (the side of the footrest next to the sliding door) through the bars. The air through the heat exchanger, washed by hot coolant and the deflector is supplied to the rear of the cabin. Inflow coolant radiator is regulated by a valve controlled by a flexible wire. Withdrawal
| PERFORMANCE ORDER | | 1. Drain the coolant (see. Subsection 2.16.3). | | 2. Pull the plug from the motor of the heater. | | 3. Remove the connecting hoses near a radiator (3), first loosening the clamps and hoses pinching suitable clamps to avoid leaking coolant (see. Fig. Removal of additional motor and a heat exchanger). |  | 4. Remove the deflector (1) in the cabin. Remove the seal (2). | | 5. Remove the screws securing the heatsink. |
|
Setting
| PERFORMANCE ORDER | | 1. Screw the heat sink and set the deflector. | | 2. Connect and fasten the coolant hose clamp. | | 3. Top up with coolant and bleed the cooling system (see. Subsection 2.16.3). |
A warning  When replacing radiator coolant replaced anyway.
|
|
| 
