 printable version
Checking the battery
There are two possibilities for testing the battery. Depending on the verification requires various control devices. Check the density of the electrolyte | The density of the electrolyte and the measured voltage give a precise opinion about charging the battery. To verify the required pear offered for sale spetsmagazinah. |
The higher specific gravity (specific gravity) of the electrolyte, the less recessed float. On a scale can determine the specific gravity g / ml or in degrees Baume (Be). You must have the following values:
Charging | ?� Be | g / ml | Discharged | 16 | 1.12 | Polurazryazhena | 24 | 12 | Well charged | 32 | 1.28 |
| PERFORMANCE ORDER | | Check sequence of each of the battery bank, all banks must use the same electrolyte density (?� 0.02 g / ml). Otherwise, the battery is faulty |
|
Check the battery under load | PERFORMANCE ORDER | | 1. Connect a voltmeter to the battery poles. | | 2. Start the engine and measure the voltage. | | 3. During startup, a fully charged battery, the voltage must not fall below 8 (electrolyte temperature of 20 ?� C). | | 4. If the voltage immediately drops and banks found different density of the electrolyte, the battery is faulty. | | 5. The total voltage can also be verified tester. |
|
Capacity | Load current, A | The minimum voltage, | 44 A4 | 200 | 9.2 | 60 A4 | 200 | 9.2 | 61 A4 | 200 | 9.4 | 72 A4 | 300 | 9.4 | 92 A4 | 300 | 9.4 |
A warning  If the measurement (lasting 10 seconds), the voltage falls below the given value, the battery is discharged or faulty or.
|
