 printable version
Removal, installation and repair backstage gear lever
If the repair or replacement of the drive gear vibration continue the shift lever while driving, it means that there is increased play in the hinge arm and must be repaired. You will need: the keys "12", "14" socket wrench "10", a screwdriver. | | 1. In the engine compartment, loosen the nut screw terminal connections of the tip of the lever and pull the shift. | 2. Remove the thrust turnbuckle ... |
| | 3. ... and a protective cover. | 4. In salon remove the front part of the lining of the tunnel floor frame cover gear lever against the force of her retainers. |
5. Remove the cover of the lever inside, snack side cutter (or cut with a knife) clamp cover and remove the cover from the lever.
NOTE Clamp cover gear lever disposable. When you install a new clamp assembly. |
| | 7. Undo the lock lever on the axis ... | 8. ... and remove the axis of the lever, pull it out of the holes of the lever and the wings. |
| | 9. Pull up and remove the gear lever. | 10. Push a screwdriver into the housing arm rezinoplastmassovuyu guide sleeve and slide it along the shaft. |
| | 11. Remove the four screws on the housing to the base of the lever body. | 12. Remove the case and remove the shaft. |
13. Remove the shaft guide bushing. 14. Inspect the removed parts. If the opening of the guide sleeve is worn or deformed array of rubber or hardened, replace the sleeve assembly. If the hinges have backstage play or badly worn a hole under the lever axis, change the scenes. 15. Install the parts in reverse order of removal.
| 
