add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Chevrolet Lanos (since 2004 of release), Daewoo Lanos (since 1997 of release)

general info. full specifications. diagnostics. hints. tips. tricks
Chevrolet Lanos
Home
 
Chevrolet
Lanos
Device Car
Operating Guidelines
Faults in the way
Maintenance
Engine
Transmission
Chassis
A steering
The brake system
Electrical
Body
Design Features
Possible malfunctions of the body, their causes and remedies
Removing, dismantling and installation of bumpers
Removing and installing radiator grille
Removal and installation of mudguards of wheels and Lockers
Removal and installation of a forward wing
Removal and installation of a lattice box vozduhopritoka
Hood
Door
The trunk lid
Manhole cover fuel tank filler pipe
Seats
Removing and installing front seat
Removing and installing front seat headrest
Removing and installing rear seat
Removal and installation of facing of a tunnel floor
Restraint System (SRS)
Rear view mirrors
Dashboard
Heater and air conditioning
Interior fittings
Removal and installation of facing of salon
Removal and installation of facing the boot
Windscreen wiper
Replacement of the fixed glass body
Removing and installing the attachment flanges of the battery
Care body
Wheels and tires
Purchase of spare parts
A trip to the STO
Winter car operation
Preparation for technical inspection
Tips novice mechanic
Applications
Diagrams
 


Hit Counter by Digits


print page printable version

Removing and installing rear seat



Rear Seat Cushion-piece and can be removed entirely. Rear backrest consists of two parts, each of which can be removed separately. The following shows the removal of the right side of the back, remove the left side is similar.
You will need: the key "12" (convenient to use face head), a stripper for removing caps or flat-blade screwdriver.
1. Lift the front part of the rear seat, print two brackets securing its right and left sides of the holes on the back.

NOTE
So look bracket cushion ...
... And so - in the back of the hole.


2. Press the upholstery in the back of the left and right cushion to gain access to the two bolts of its fastening to the body ...
3. Remove the bolts ... ...
4. ... and remove the rear seat cushion from the passenger compartment.
5. Access to the bolts securing the right side of the rear seat back is closed trunk edge trim attached to the body of the three pistons. Remove the trim from the edge of the body ...
6. ... removing caps pliers or a screwdriver prying ...
... 7. Remove the two screws on the right side of the backrest to the bracket ...
8. Slide the right-hand side ... back down and left ...
9. ... to remove the clip from the back of the hole in the back, and remove the right side of the rear seat back to the vehicle.
10. If necessary, replace the rear seatback lock button to unscrew the lock actuator rod ...
11. ... unscrew the two nuts securing the lock to the frame of the seat ...
12. ... and remove the lock.
13. To remove the latch lock the rear seatback remove the rear quarter panel trim (see. "Removal and installation of facing interior") and remove the two screws on the latch to the body.
14. Install the rear seat and all the removed parts in reverse order of removal.




« previos page
Removing and installing front seat headrest
next page »
Removal and installation of facing of a tunnel floor

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.