add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Chevrolet Lanos (since 2004 of release), Daewoo Lanos (since 1997 of release)

general info. full specifications. diagnostics. hints. tips. tricks
Chevrolet Lanos
Home
 
Chevrolet
Lanos
Device Car
Operating Guidelines
Faults in the way
Maintenance
Engine
Transmission
Chassis
A steering
The brake system
Electrical
Body
Design Features
Possible malfunctions of the body, their causes and remedies
Removing, dismantling and installation of bumpers
Removing and installing radiator grille
Removal and installation of mudguards of wheels and Lockers
Removal and installation of a forward wing
Removal and installation of a lattice box vozduhopritoka
Hood
Door
The trunk lid
Manhole cover fuel tank filler pipe
Seats
Removal and installation of facing of a tunnel floor
Restraint System (SRS)
Rear view mirrors
Dashboard
Heater and air conditioning
Device features
Removing and installing control unit heating and air conditioning
Interior fittings
Removal and installation of facing of salon
Removal and installation of facing the boot
Windscreen wiper
Replacement of the fixed glass body
Removing and installing the attachment flanges of the battery
Care body
Wheels and tires
Purchase of spare parts
A trip to the STO
Winter car operation
Preparation for technical inspection
Tips novice mechanic
Applications
Diagrams
 


Hit Counter by Digits


print page printable version

Removing and installing control unit heating and air conditioning



You will need: a screwdriver with a flat blade and Phillips.
1. Disconnect a wire from the plug "minus" of the storage battery.
2. wrung out a screw-driver spring clamps on both sides facing the console dashboard lining up ...
3. ... and at the bottom, remove the cover.
4. Remove the two screws securing the plug box to install the radio ...
5. Pull the plug ... from the dashboard, disconnect the plug connector harness, remove from its holder and remove the antenna cable plug.
6. Remove from the slot dashboard mounting box recorder.
7. Remove the two screws that secure the instrument panel to the control unit with heating and air conditioning ...
8. ... three output latch at the top of the block out of engagement with the instrument panel and move the block so far as the length of the wires and rods.
9. Disconnect from the power harness pads.
10. wrung out finger clip shell traction control valve air distribution ...
11. ... unplug heater shell from the body and remove the rod with a thumb throttle lever.
12. Similarly disconnect the heater from the levers of traction control valves controlling the temperature of the air entering the cabin ...
13. ... and recirculation.
14. Remove the control unit with heating and air conditioning, along with rods. If necessary, disconnect the unit from the thrust levers in the same way as it did when you disconnect from the levers of the heater (see. Pp. 11-14).
15. Install the control unit heating and air conditioning and all the removed parts in reverse order of removal.




« previos page
Device features
next page »
Interior fittings

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.