 printable version
Removal and installation of the lock of a cover of the hatch of a bulk pipe of a fuel tank and its drive
You will need: all the tools you need to remove the back facing the floor and left the threshold of facing the trunk and face head "10". | | 3. Turn out through a window in the floor mat bolt unit handles. | 4. Bend the edge of the mat and pull the rug from under the unit handle with Bowden cable, extending the unit through a window in the floor cross member. |
5. Remove the slot bracket unit levers tip sheath drive lock hatch of a bulk pipe of a fuel tank, and removing the tip of a cable from the slot lever, disconnect the cable.
NOTE If necessary, disconnect the unit is similar to the arms control cable lock trunk (with a yellow tip) and remove the unit handles. |
| | 6. Remove the cover of a cable from the holder on the left verge of the floor ... | 7. ... on the left side in the trunk ... |
| | 8. ... and the rear end panel of the amplifier. | 9. Open the hatch cover fuel filler, and remove from the slot on the right rear wing locking manhole cover fuel tank filler tube, overcoming the resistance of his retainers. |
| | 10. Remove the lock lever from the tip of a cable ... | 11. ... disconnect the lock body and the tip of the sheath and remove the lock. |
12. Remove the drive cable, removing both ends in the trunk. 13. Inspect the seal lock. Strongly hardened or damaged, replace the gasket. 14. Install in the reverse order of removal, locking hatch of a bulk pipe of a fuel tank and drive, as well as all the removed parts.
| 
