add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Chevrolet Lanos (since 2004 of release), Daewoo Lanos (since 1997 of release)

general info. full specifications. diagnostics. hints. tips. tricks
Chevrolet Lanos
Home
 
Chevrolet
Lanos
Device Car
Operating Guidelines
Faults in the way
Maintenance
Engine
Transmission
Chassis
A steering
The brake system
Electrical
Body
Design Features
Possible malfunctions of the body, their causes and remedies
Removing, dismantling and installation of bumpers
Removing and installing radiator grille
Removal and installation of mudguards of wheels and Lockers
Removal and installation of a forward wing
Removal and installation of a lattice box vozduhopritoka
Hood
Removing and installing bonnet
Removal, installation and adjustment of the bonnet and drive
Door
The trunk lid
Manhole cover fuel tank filler pipe
Seats
Removal and installation of facing of a tunnel floor
Restraint System (SRS)
Rear view mirrors
Dashboard
Heater and air conditioning
Interior fittings
Removal and installation of facing of salon
Removal and installation of facing the boot
Windscreen wiper
Replacement of the fixed glass body
Removing and installing the attachment flanges of the battery
Care body
Wheels and tires
Purchase of spare parts
A trip to the STO
Winter car operation
Preparation for technical inspection
Tips novice mechanic
Applications
Diagrams
 


Hit Counter by Digits


print page printable version

Removal, installation and adjustment of the bonnet and drive



You will need: the key "10" (easier to face head), flat-blade screwdriver.
To remove the bonnet, proceed as follows.
1. Open the hood and place it on the palm.
2. Remove the three screws securing the bonnet to the radiator frame ...
3. ... take away the lock from the frame, the tip sheath output drive of the lock from the holder on the body of the castle ...
... 4. Disconnect the cable end of the lock lever and remove the lock.
5. Install the hood latch in the reverse order of removal. Before installing the bonnet lubricate it with grease detail, such as lithologic.
6. If you have installed the lock clearly locked or unlocked hard to adjust its position. Loosen the lock bolts and moving it within the oval holes housing Achieve precise work.

To remove the bonnet, proceed as follows.
1. Disconnect the cable from the bonnet (See above. Nos. 3 and 4 in this section).
2. Open the left front door and prying with a screwdriver ...
... 3. Remove the left side cover of the instrument panel.

NOTE
Side cover the dashboard should be removed for visual access to the site of attachment handle the bonnet.

4. Remove the two screws on the drive arm to the dashboard ...
5. ... print with rope handle of the instrument panel ...
6. ... and lower it down from the panel.
7. Disconnect the cable end of the bonnet lever handle ...
... 8. Pull the cable housing out of the way into the body of the handle and remove the handle of the rope, passing it all the way into the slot.
9. In the engine compartment, remove the cable holder from the holes in the left front ...
10. ... and the upper cross frame radiator, and then remove the cable by pulling it in the engine compartment.
11. Install the parts in reverse order of removal.




« previos page
Removing and installing bonnet
next page »
Door

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.