add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks
Hyundai Accent
Home
 
Hyundai
Accent
Instructions
Engine
Engines SOHC
Technical data
Toothed belt
Check toothed belt tension
Adjusting the tension of the toothed belt
Ribbed Belts
Engine Supports
The front cover and the oil pump
Air filter (ACL)
Cylinder head
Rocker
Hydraulic jacks of backlashes of valves
Replacing the valve seat
Replacing the valve guide
Valve
Camshaft
Cranks
Crankshaft
Flywheel
The piston pin
An exhaust manifold
Intake manifold and the air chamber
Cylinder block
Removing and installing engine and gearbox
Exhaust
Troubleshooting
Engines DOHC
Greasing system
Cooling
Control, reduced toxicity
Fuel system
Ignition system
Coupling
Transmission
Axes and power shafts
Suspension
Steering
Brakes
Body
Air
Electrical equipment
Appendix
Wiring
 


Hit Counter by Digits


print page printable version

Hydraulic jacks of backlashes of valves



Fill the hydraulic jacks of backlashes of valves with engine oil, keep upright and your fingers to squeeze the two sides.


The basic malfunctions of hydraulic jacks of backlashes of valves, causes and solutions are listed in the table.

Malfunction
Possible causes
Remedy
Temporary noise when starting from cold. Normal The noise disappears after warming up the engine oil and achieve a normal pressure
Continuous noise after the engine has not been run for 48 hours. Oil leaked from the chambers of hydraulic jacks of backlashes of valves, and they hit the air The noise will disappear after 15 minutes of engine operation when the crankshaft reaches a speed of 2000-3000 min -1
A warning

Do not increase the engine speed of the engine above 3000 min -1, as this may damage the hydraulic jacks of backlashes of valves.


Continuous noise after starting the engine and replace the cylinder head Insufficient oil in the engine oil ducts
Continuous noise after a long start motor starter or towed Oil leaked from the chambers of hydraulic jacks of backlashes of valves, and they hit the air
Continuous noise after replacing the hydraulic jacks of backlashes of valves
Continuous noise at the frequency of idling after driving at high speed The engine oil level is too low or too high Check the engine oil level
A large amount of air dissolved in the oil after high speed Check the oil supply
Deterioration of motor oil Check the oil and, if necessary, replace it
The noise lasts longer than 15 minutes The low pressure in the lubrication system Check the pressure in the lubrication system
Defective hydraulic jacks of backlashes of valves Remove the cylinder head and pressing the hydraulic jacks of backlashes of valves, check the value of compression




« previos page
Rocker
next page »
Replacing the valve seat

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.