REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Accent
		Instructions
		Engine
		Greasing system
		Cooling
		Control, reduced toxicity
		Fuel system
		Ignition system
		Coupling
		Transmission
		Axes and power shafts
		Suspension
		Steering
		Brakes
		Body
		Air
			Technical data
			Instructions for use of the refrigerant
			Remarks at replacement of elements of the air conditioning system
			Merging an air-conditioning system
			Testing the air-conditioning system installed in the car
			Setting gauges for pressure measurement
			The evacuation of air from the air conditioning system
			Charge air-conditioning system
			Checking the coolant level
			Verification performance
			Oil for air conditioning compressor
			Relay test
			Air conditioning compressor
			Bushing clutch pulley and the air conditioning compressor
			The excitation coil clutch
			Check the compressor by car
			Triple Sensor (double) Pressure
			The fan and the condenser
			Evaporator
			Checking the thermostatic sensor (thermistor)
			The air filter of the evaporator
			Block heating and ventilation
			Block heater
			Fan
			Troubleshooting
		Electrical equipment
		Appendix
		Wiring

printable version

The fan and the condenser

1 - a tank capacitor;
2 - condenser fan;

3 - the bolt of the condenser fan;
4 - capacitor.

Withdrawal

PERFORMANCE ORDER

1. Discharge the air conditioning system.
2. Drain the coolant from the radiator.
3. Remove the two screws securing the upper clamp of the radiator and air intake pipe.
	4. Remove the two clamps and the inlet pipe.
5. Disconnect the radiator inlet and outlet hoses.
6. Disconnect hoses from the oil cooler gearbox.
7. Disconnect from the radiator fan and condenser fan.
8. Remove the complete radiator and condenser.
9. Disconnect from the condenser outlet pipe and a coolant tube.
	A warning After separation of the air conditioning system components immediately close the connection corresponding caps to eliminate moisture from the air into the system. Be careful not to damage the exhaust pipe and a coolant tube. Be careful not to damage the capacitor plates.
10. Remove the two screws on the condenser.
	11. Remove the condenser.

Check condenser fan

PERFORMANCE ORDER

1. Check the operation of the condenser fan.

2. Check the electrical wiring harness connector.

3. The fan motor is rotated at a supply voltage of 12 V on the connector pins of the fan motor.

Setting

PERFORMANCE ORDER

1. Installation is spent to sequences, return to removal.

2. If replacement of the condenser, add 25 cm to the compressor ³ oil.

3. Pump, recharge and check air-conditioning system.

Checking capacitor car

PERFORMANCE ORDER

1. Check the capacitor plates to clogging and damage. If the plates are clogged, wash them with clean water and blow compressed air. If the bent plate, align them with pliers and a screwdriver.

2. Check the space connecting the condenser leak.

« previos page
Triple Sensor (double) Pressure

next page »
Evaporator