REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Accent
		Instructions
		Engine
		Greasing system
		Cooling
		Control, reduced toxicity
		Fuel system
		Ignition system
		Coupling
		Transmission
		Axes and power shafts
		Suspension
		Steering
		Brakes
		Body
		Air
			Technical data
			Instructions for use of the refrigerant
			Remarks at replacement of elements of the air conditioning system
			Merging an air-conditioning system
			Testing the air-conditioning system installed in the car
			Setting gauges for pressure measurement
			The evacuation of air from the air conditioning system
			Charge air-conditioning system
			Checking the coolant level
			Verification performance
			Oil for air conditioning compressor
			Relay test
			Air conditioning compressor
			Bushing clutch pulley and the air conditioning compressor
			The excitation coil clutch
			Check the compressor by car
			Triple Sensor (double) Pressure
			The fan and the condenser
			Evaporator
			Checking the thermostatic sensor (thermistor)
			The air filter of the evaporator
			Block heating and ventilation
			Block heater
			Fan
			Troubleshooting
		Electrical equipment
		Appendix
		Wiring

Fan

1 - tube cooling fan motor;
2 - the block of resistors;
3 - an air inlet;
4 - damper shaft inlet;

5 - the top of the fan housing;
6 - lower the fan housing;
7 - fan wheel;
8 - fan motor;
9 - Cover the fan motor.

Refitting

PERFORMANCE ORDER

1. Remove the instrument panel.
2. Disconnect from the electric motor and fan unit resistors.
3. Remove the nuts and remove the evaporator unit.
4. Remove the 3 nuts (or bolts) fan bracket.
5. Remove the fan assembly.
	6. Install in the reverse order of removal.

Withdrawal

PERFORMANCE ORDER

	1. Disconnect the cooling fan motor.
2. Remove the three screws and remove the fan motor.
	3. Release the clamps that secure the air intake fan to the upper body.
4. Remove the air intake.
	5. An edge of a flathead screwdriver to release the six clips and separate the top and bottom of the fan housing.
6. Remove the two screws and remove the fan resistor.
7. The assembly is carried out in sequence, return dismantling.

Check the fan motor

PERFORMANCE ORDER

Additional wires submit pressure from the battery to the contacts and the fan motor connector. If fan motor rotates, then it is OK.

« previos page
Block heater