REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Accent
		Instructions
		Engine
		Greasing system
		Cooling
		Control, reduced toxicity
		Fuel system
		Ignition system
		Coupling
		Transmission
		Axes and power shafts
		Suspension
		Steering
			Technical data
			The mechanism of the tilt steering column
			Steering transfer without power steering
			Tie Rod
			Check backlash steering wheel for vehicles with power steering
			Checking steering angle of front wheels
			Check torque pin of the spherical rod end
			Check of effort of the steering wheel for vehicles with power steering
			Checking the steering wheel return to its original position
			Check the fluid level
			Liquid replacement in a hydraulic drive the power steering
			Bleeding the hydraulic system of the power steering
			Checking the belt drive power steering pump
			Checking the fluid pressure in the hydraulic system
			Steering transfer of cars with power steering
			The power steering hoses
			Power steering pump
			Troubleshooting (steering without the amplifier)
			Troubleshooting (power steering)
		Brakes
		Body
		Air
		Electrical equipment
		Appendix
		Wiring

printable version

Bleeding the hydraulic system of the power steering

PERFORMANCE ORDER

1. Disconnect the high-voltage wire from the ignition coil. Periodically turn the starter for 15-20 seconds and at the same time 5-6 times turn a steering wheel from lock to lock.

A warning

In the process of pumping the liquid is constantly top up to the level in the reservoir does not fall below the filter settings.
If pumping perform when the engine crankshaft is not rotating, the air is again dissolved in the liquid. Ensure that you are pumping at the time of cranking the engine.

2. Connect the high-voltage wire to the ignition coil, start up the engine and let it run at idle speed.

3. Turn the steering wheel from lock to lock several times. Make sure that the liquid does not foam and its level has not gone down.

A warning

To avoid damage, do not hold the steering wheel turned fully for longer than 10 seconds.

4. Make sure that the liquid does not have a milky color, and the level is between the marks on the dipstick.

5. Check that there is a slight change in the fluid level when the steering wheel to the left and right sides.

A warning

If the fluid level varies considerably, repeat pumping hydraulic power steering.
If the fluid level rises suddenly after the engine stops, it means that the system still has the air.
If the hydraulic drive the power steering has the air when the pump will hear background noise. Air in the system will reduce the life of the pump and other parts.

« previos page
Liquid replacement in a hydraulic drive the power steering

next page »
Checking the belt drive power steering pump