REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Accent
		Instructions
		Engine
		Greasing system
		Cooling
		Control, reduced toxicity
		Fuel system
		Ignition system
		Coupling
		Transmission
		Axes and power shafts
		Suspension
		Steering
			Technical data
			The mechanism of the tilt steering column
			Steering transfer without power steering
			Tie Rod
			Check backlash steering wheel for vehicles with power steering
			Checking steering angle of front wheels
			Check torque pin of the spherical rod end
			Check of effort of the steering wheel for vehicles with power steering
			Checking the steering wheel return to its original position
			Check the fluid level
			Liquid replacement in a hydraulic drive the power steering
			Bleeding the hydraulic system of the power steering
			Checking the belt drive power steering pump
			Checking the fluid pressure in the hydraulic system
			Steering transfer of cars with power steering
			The power steering hoses
			Power steering pump
			Troubleshooting (steering without the amplifier)
			Troubleshooting (power steering)
		Brakes
		Body
		Air
		Electrical equipment
		Appendix
		Wiring

The mechanism of the tilt steering column

PERFORMANCE ORDER

1. Install the universal joint shaft pinion steering gear.
A warning If the steering wheel is equipped with a mechanism for adjusting the angle of inclination, observe the following conditions. Failure to meet these conditions can result in deformation of the bracket angle, whereby the lever may be damaged and a tilt lock lever.
	2. Before installation, check that the bracket has a hole for the pin. 1) If so, fix the angle of the lever in neutral and set the lock pin into the hole, and then disconnect the lever angle.
	2) Otherwise, fasten the lever angle around the neutral position.
	3. Replace the screw that secures the steering shaft U-shaped member of the universal joint. Torque: 15-20 N ??? m
	4. Temporarily tighten the two mounting screws.
5. Screw the two mounting screws. Torque: 13-18 N ??? m
6. Tighten to torque the two mounting bolts.
	7. If detent pin is installed, move the steering column to the lower position.

« previos page
Technical data