REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Elantra (from 2000 to 2004, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Elantra
		Gasoline engines 1.6, 1.8 and 2.0 liters
		The diesel engine of 2.0 liters
		Greasing system
		Cooling
		Fuel system
		Control systems and emission control
		Ignition system
		The system of preliminary heating of the diesel engine
		Coupling
		Manual transmission
		Automatic Transmission
			Technical data
			Check the fluid level in automatic transmission
			Substitution fluid in an automatic transmission
			Check conduction switch the transmission range (F4A42)
			Switch the transmission range and adjustment of the control cable (F4A42)
			Check the operation of the selector lever (A4AF3)
			Adjustment of the switch indicate the position of the selector lever (A4AF3)
			Component testing of an automatic transmission (F4A42)
			Testing of teamwork of an automatic transmission and the engine for the motionless car (F4A42)
			Check the transmission fluid pressure (F4A42)
			Check the transmission fluid pressure (A4AF3)
			The diagnostic function
			Diagnostic codes
			Adjustment of an axial backlash reaction brake (F4A42)
			Adjusting the axial clearance of the brake of the second transmission (F4A42)
			Adjusting the axial clearance of the brake transmission and low reverse gear (F4A42)
			Adjusting the axial clearance of the sun gear downshift (F4A42)
			Adjusting the preload of the differential (F4A42)
			Elements of hydraulic control system
			Identification of bearing automatic transmission F4A42
			The control lamp fault (MIL)
			Identification of bearing automatic transmission F4A43
			Adjusting the servo compulsory inclusion downshift (A4AF3)
			Adjust the line pressure (A4AF3)
			Replacement of an oil sealing ring of a power shaft
			Removing and installing transmission F4A42
			Removing and installing transmission A4AF3
			Control automatic transmission
			Installing the locking device
			Installing a locking key
		Drive shafts, front and rear axles
		Suspension
		Steering
		Brakes
		Body
		The air conditioning system
		Electrical equipment
		Electrical diagrams

printable version

Adjusting the preload of the differential (F4A42)

Place solder (about 10 mm in length 3 mm in diameter) on the converter housing as shown.

Install the torque converter housing to the gearbox housing without using the sealant. Tighten the bolts to the recommended torque specification. Remove the screws and remove the solder.

Use a micrometer to measure the thickness (T) of compressed solder. Select the gasket, the thickness of which is within the calculated value. Standard thickness: from (T 0,045 mm) to (T 0,105 mm).

« previos page
Adjusting the axial clearance of the sun gear downshift (F4A42)

next page »
Elements of hydraulic control system