 printable version
Wipers and windshield washer
Withdrawal Setting |  | - Install the wiper arm to a certain position.
|
| The mounting position of the wiper arm | A | AT | | Distance, mm | 35 ?� 5 | 35 ?� 5 |
 | - Adjust the spray nozzle so that they sprayed the liquid in the exact locations on the windshield.
|
|
|
Check  | Check conductivity between socket contacts switch of a cleaner and a windscreen washer. If the conductivity does not correspond demanded, replace the switch of a cleaner and a windscreen washer.
|
Wiper Switch (M01-1) Switch the washer (M01-1) Check the frequency of wiper | - Disconnect the connector from the wiper motor.
- Additional wires connect the positive battery terminal to terminal 4 of the connector and the negative terminal - to terminal 1.
- Make sure the wiper motor operates at low speed.
- Additional wires connect the positive battery terminal to terminal 4 of the connector and the negative terminal - to terminal 2.
 | - Make sure the wiper motor runs at high speed.
|
|
|
Checking the brushes for automatic stop in the initial state | - Start the engine at low speeds.
- Disconnect the 3 connectors, stop the engine in any position other than the original.
- Connect terminals 1 and 5 of the connector.
- Additional wires connect the positive battery terminal to terminal 4 of the connector and the negative terminal - to terminal 3.
 | - Check that the wiper motor is switched off in the starting position of the wiper blades.
|
|
|
Testing the engine washer | - With the motor connected to the windshield washer tank, fill the washer tank with water.
- Additional wires connect the positive terminal of the battery to terminal 2 and the negative terminal - to terminal 1, the engine must be running and the pump to pump water.
|
|
|
