add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Jeep Grand Cherokee (from 1993 to 1999, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Jeep Grand Cherokee
Home
 
Jeep
Grand Cherokee
Introduction
Adjustment and routine maintenance
The straight six-cylinder engine
The V8 engine
Procedure of the general and engine major repairs
Systems of cooling, heating and air conditioning
The power supply system and exhaust
The system of electric motor
Systems of decrease in toxicity of the fulfilled gases and engine management
Manual box of a gear change
Automatic Transmission
general information
Troubleshooting - General Information
Removing and installing selector lever
Check and adjustment of a cable switch
Description, replacement and adjustment of the throttle cable mode kickdown (TV-cable)
Check of adjustment and replacement of the gauge-switch of the permission of start
Adjustment of a cable parking bollard
Check and replacement of support of transmission
Replacing the gland
Description of the construction, removal and installation of lines and transmission cooling hoses
Removal and installation of additional cooling
Removing and installing automatic transmission
Replacing the transmission control module (TCM) (only for the AW-4 and 42RE)
Diagnosis of electronically controlled automatic transmission
Transfer Case
Clutch and transmission line
Brakes
Suspension and steering
Body
The system of on-board electrical equipment
Controls and operation receptions
 


Hit Counter by Digits


print page printable version

Check and adjustment of a cable switch



Check

Cock to lock the parking brake and attempt to short the starter for all positions of the shift lever. The inclusion of a starter should take place only in the lever positions "P" and ?�N?�. If the starter motor is started at any of the other provisions of the lever, adjust the thrust (See below.). If the adjustment is still the starter is activated when other than "P" or ?�N?� position of transmission should make adjustment of the gauge-switch of the permission to start or replace it (Section Check of serviceability, adjustment and replacement of the gauge-switch of the permission of start).

Adjustment

PERFORMANCE ORDER

  1. Set the gear lever to position "P". Poddomkratte car and establish it on props.
  2. To release the shift cable wire casing separate from the bracket, then, to release the cable adjustment clip release it.
  1. Cable switch is connected to the lever switch via the docking connector type ball-breeding; to disconnect a connector skovyrnite tip of a cable with a small pin on the arm with a screwdriver.
  1. To disconnect the cable from the bracket with the locking pliers, squeeze the tabs on the housing, then pull the cable to the housing from the bracket.
  1. Make sure that the shift lever on the transmission set aside all the way back to the last clip. In this transmission will be in position "P".
  2. Make sure that the parking lock is working, what do try rotating the propeller shaft. In normal operation it is impossible to lock the shaft will rotate.
  3. Clip shift cable housing into the bracket, and then press down until it clicks adjusting clamp fixing the cable thereby.
  4. Lower the car to the ground.
  5. When the parking brake firmly cocked make sure that the starter is only possible in the positions of transmission "P" and ?�N?�. If the draft is adjusted properly, but the starter is started at positions other than the "P" and ?�N?�, check if the gauge-switch of the permission of start (Section Check of serviceability, adjustment and replacement of the gauge-switch of the permission of start).
  6. Check out the smooth operation of the lock steering wheel lock.




« previos page
Removing and installing selector lever
next page »
Description, replacement and adjustment of the throttle cable mode kickdown (TV-cable)

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.