- Move the lever to the "P" and the ignition key - in position LOCK (Blocking).
- Give fixing screws facing the shift lever and console (Chapter Body).
- To release the cable, pull the release button.
 | - To release the cable, pull the release button.
|
- Pull the cable forward, then release it and squeeze the release button down until it clicks.
 | - Pull the cable forward, then release it and squeeze the release button down until it clicks.
|
- To check the adjustment, perform the following procedure:
- Move the lever to the "P".
- Check the operation of the lock release button in the handle of the lever and the ignition lock cylinder. The button must be in the disengaged position (released), and the ignition lock cylinder to rotate freely between OFF and LOCK.
- Move the lever to the DRIVE (Drive) or REVERSE (Reverse gear) and re-verify the proper operation of the ignition lock cylinder. At this time, the cylinder must not rotate.
- Check the operation of the shift lever. Removes it from the position "P" must be possible only when the cylinder ignition is turned to OFF (Off), RUN (movement) or START (launch). When you are in the positions of the lock cylinder ACCESSORY (parking) or LOCK (Lock).
|
|
