REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Jeep Grand Cherokee (from 1993 to 1999, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Jeep
	Grand Cherokee
		Introduction
		Adjustment and routine maintenance
		The straight six-cylinder engine
		The V8 engine
		Procedure of the general and engine major repairs
		Systems of cooling, heating and air conditioning
		The power supply system and exhaust
		The system of electric motor
		Systems of decrease in toxicity of the fulfilled gases and engine management
		Manual box of a gear change
		Automatic Transmission
			general information
			Troubleshooting - General Information
			Removing and installing selector lever
			Check and adjustment of a cable switch
			Description, replacement and adjustment of the throttle cable mode kickdown (TV-cable)
			Check of adjustment and replacement of the gauge-switch of the permission of start
			Adjustment of a cable parking bollard
			Check and replacement of support of transmission
			Replacing the gland
			Description of the construction, removal and installation of lines and transmission cooling hoses
			Removal and installation of additional cooling
			Removing and installing automatic transmission
			Replacing the transmission control module (TCM) (only for the AW-4 and 42RE)
			Diagnosis of electronically controlled automatic transmission
		Transfer Case
		Clutch and transmission line
		Brakes
		Suspension and steering
		Body
		The system of on-board electrical equipment
		Controls and operation receptions

Check and replacement of support of transmission

PERFORMANCE ORDER

Poddomkratte car and establish it on props.
Under the car, insert a large screwdriver or pry bar into the space between the transmission case and extension transverse beam (models 2WD), or the transfer case and the cross bar (all-wheel drive models). Try to gently pry the transmission or transfer case. Transmission should not be any noticeable rise above the support pillow

To check the support of the transmission mount or insert a large screwdriver between the housing and the extension of cross beam (models 2WD) or between the transfer case and the cross bar (model 4WD) and try to lift this lever transmission over its support.

To replace the cushions support the bolts give it to the cross beam and the transmission.

Components of a typical support assembly of the transmission.

Slightly lift the transmission or transfer case and remove the jack pad support. Note that in the cross beam are provided holes for centering support during installation.
Install in reverse order. Track reliability of a tightening of fixture.