add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Jeep Grand Cherokee (from 1993 to 1999, the year of issue)
general info. full specifications. diagnostics. hints. tips. tricks
 Jeep Grand Cherokee
Home
 
Jeep
Grand Cherokee
Introduction
Adjustment and routine maintenance
The straight six-cylinder engine
The V8 engine
Procedure of the general and engine major repairs
Systems of cooling, heating and air conditioning
The power supply system and exhaust
The system of electric motor
Systems of decrease in toxicity of the fulfilled gases and engine management
Manual box of a gear change
Automatic Transmission
Transfer Case
Clutch and transmission line
Brakes
Suspension and steering
general information
Removing and installing front stabilizer lateral stability and bushings
Removal and installation of the front shock absorbers
Removal and installation of the transverse jet bar front suspension
Removal and installation of the front suspension arms
Removing and installing coil spring front suspension
Removing and installing steering knuckle
Replacement ball joints
Removing and installing rear stabilizer rod transverse stability
Removing and installing the rear shock absorbers
Removal and installation of the transverse jet bar rear suspension
Removal and installation of levers of a back suspension
Removing and installing coil spring rear suspension
Removing and installing steering wheel
Condition check, removal and installation of steering gear
Removal and installation of the steering mechanism
Removal and installation of the pump system hydrostrengthening steering
Bleeding the steering system hydrostrengthening
Wheels and tires - general information
Corners of installation of forward wheels - the general information
Body
The system of on-board electrical equipment
Controls and operation receptions
 


Hit Counter by Digits


print page printable version

Removal and installation of the transverse jet bar rear suspension



PERFORMANCE ORDER

  1. Poddomkratte back of the car and establish it on props.
  2. Give a nut and bolt on the frame rail bracket.

Details of the installation of reactive rod.

  1. To remove the upper end of the jet bar of the bracket beams give the frame bolt (arrow) and a nut (not visible in the picture).
  1. Give a nut and bolt sleeve axle bracket and remove the torque rods.
  1. To remove the lower end of the rod from the jet bridge arm sleeves give this bolt (arrow) and nut (the picture is not visible).
  1. Install in reverse order. All fixture tighten with demanded effort.




« previos page
Removing and installing the rear shock absorbers		 next page »
Removal and installation of levers of a back suspension

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.