REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Jeep Grand Cherokee (from 1993 to 1999, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Jeep
	Grand Cherokee
		Introduction
		Adjustment and routine maintenance
		The straight six-cylinder engine
		The V8 engine
		Procedure of the general and engine major repairs
		Systems of cooling, heating and air conditioning
		The power supply system and exhaust
		The system of electric motor
		Systems of decrease in toxicity of the fulfilled gases and engine management
		Manual box of a gear change
		Automatic Transmission
		Transfer Case
		Clutch and transmission line
		Brakes
		Suspension and steering
			general information
			Removing and installing front stabilizer lateral stability and bushings
			Removal and installation of the front shock absorbers
			Removal and installation of the transverse jet bar front suspension
			Removal and installation of the front suspension arms
			Removing and installing coil spring front suspension
			Removing and installing steering knuckle
			Replacement ball joints
			Removing and installing rear stabilizer rod transverse stability
			Removing and installing the rear shock absorbers
			Removal and installation of the transverse jet bar rear suspension
			Removal and installation of levers of a back suspension
			Removing and installing coil spring rear suspension
			Removing and installing steering wheel
			Condition check, removal and installation of steering gear
			Removal and installation of the steering mechanism
			Removal and installation of the pump system hydrostrengthening steering
			Bleeding the steering system hydrostrengthening
			Wheels and tires - general information
			Corners of installation of forward wheels - the general information
		Body
		The system of on-board electrical equipment
		Controls and operation receptions

printable version

Removing and installing coil spring rear suspension

PERFORMANCE ORDER

Loosen the nut of the front wheels. Poddomkratte the front of the car and establish it on props. Remove the wheels.
Mark the position and remove the cross from the holder of the differential pinion front propeller shaft (Chapter Clutch and transmission line), and then tie up the shaft of the piece of wire.
Support the assembly of the bridge, or a jack under the differential set or two, places for each of their arms (the latter method gives better balance). Otboltite lower suspension arms of the bridge (Section Removal and installation of the front suspension arms).
Otboltite stabilizer and shock absorbers on the front axle housing (Sections Removal and installation of rear anti-roll bar rod stability and Removing and installing the rear shock absorber).
Disconnect the torque rods of the bracket axle (Section Removal and installation of cross-reactive rod rear suspension).
Slowly lower the assembly of the bridge so that the coil springs fully stretched. If Propping bridge uses only one jack, have an assistant hold the bridge to the right as it is lowered. Remove the spring out of the vehicle.
Check the spring for defects and corrosion that can cause its premature failure. If necessary, replace.
Install in reverse order. Make sure of correctness of landing coil spring (see. All fixture tighten with demanded effort.

« previos page
Removal and installation of levers of a back suspension

next page »
Removing and installing steering wheel